Description
Polident Power Max Hold Seal is designed to help block out irritating food particles while providing a firm, long-lasting hold.
The precision nozzle with a finer tip enables exactly the right amount of product to be applied around the edge of your denture forming an all-round seal.
How to use Polident Hold+ Seal Denture Adhesive
- To apply to a full denture (upper or lower)
- Clean and dry your dentures
- Apply Polident Power Max Hold Seal as shown in the diagram, not too close to the denture edges.
- A. Upper Denture: Apply in a long continuous strip. Apply 2 shorter strips in the middle of the denture. B. Lower Denture: Apply product in a long continuous strip.
- Rinse your mouth before inserting dentures
- Press dentures in place, hold firmly, and bite down for a few seconds to secure hold.
- To apply to a partial denture
- Clean and dry your dentures
Apply Polident Power Max Hold Seal as shown in the diagram, not too close to the denture edges. C. Partial Denture: Apply 2 short strips. - Rinse your mouth before inserting dentures
- Press dentures in place, hold firmly, and bite down for a few seconds to secure hold.
- Refer to pack instructions. Always follow the directions. Apply once a day. If you need to apply more than once a day, seek advice from your dental care professional.
To Remove
- Swish your mouth with warm water, then slowly remove your denture using a rocking motion
- Remove adhesive residue from your denture and mouth using warm water and a soft brush
- Use Polident Denture Cleansers to thoroughly clean your denture and then rinse with water
